Jet Technology, LLC

All remanufactured presses are rebuilt from the ground up using the finest quality materials available. Below is a list which specifies in detail exactly what we replace in our remanufactured presses along with some photos of some of our recently shipped remanufactured units.

Feeder

New seals / discs
Feed belts
Bogie wheels bearings
Cast iron feeder
New feed chains installed
New bogie rollers
New sucker bar
New belts (2) sets
Rebuilt tension assemblies
Rebuilt Rocker arm
New cam follower
New bushings
New tie rods
Belt pulleys will be resurfaced or replaced

Aligner Section

Universal aligner rails will be installed
New Pusher chains
Two whole registration
Hold down guides will be rebuilt
New pusher chains
Spring loaded take-ups
New Micro switches
Improved upper entrance roller
New lower entrance roller
Entrance roller assembly will be rebuilt
New aligner bushings
Outboard drive
Rebuilt power drive assembly (hand wheel Assembly)
Belt drive
New front aligner sprockets

Impression

New bronze and gray eccentrics
Blanket cylinder supports will be rebuilt or replaced
Plate cylinders will be rebuilt or replaced (.001 tolerance will be held)
New plate cylinder shafts
4-pin dog and flange plates
Larger nut plates
New bearings

New skew bars (your choice tucking Vs non-tucking)
New blanket cylinder shaft
Blanket cylinder will hold tolerance of .001 or less
Re-located impression trip cam
Heavy-duty blanket cylinder, shafts and supports will be installed
New gib blocks
Impression cylinder will receive new housings and plugs if necessary
New bearings
Impression adjustment assembly will be rebuilt
New bushings
New springs
Double solenoids (60) HZ standard
New tie rods

Print Heads

Copper rollers will be resurfaced or replaced
Oscillating gearboxes will be rebuilt
New Bearings in all gears
New bearings on all rollers
Rebuilt fountain #2 disconnect
New style ink form arms
New rubber rollers
Worn ink fountain rollers will be replaced
New fountain blades
New fountain cheeks
Ink fountains will be remanufactured
New lamps
New bushings
New springs
New style knock off assemblies
Stripper assembly will be rebuilt and modified

Dampener Systems

Frames will receive new zinc coating
New brakes
New bearings
Worn gears replaced
Worn Chrome rollers will be replaced
New dampener tanks,
New recirculating pumps
Venturi returns
New water hose
Refrigerated systems available at an additional charge ****
New gib bushings will be installed
New springs

Delivery Tables

New belts
New bearings
Heavy duty lolli-pops

Electrical

All electronics will be gone through, when necessary new electrical boxes are installed
we use relay logic unless otherwise required

Motors will be gone through by motor shop and rebuilt or replaced as necessary
New safety and sensor switches will be installed
New lamps
New sensor wire
Remote stop and vacuum controls will be installed
Impression solenoids are 60 Hz standard
Knock off solenoids are 60 Hz Standard

Miscellaneous

Generally oil-less vacuum pumps are installed with 3 phase motors
Any items showing wear in addition to the above items listed will be replaced
All original OEM safety covers will be installed
Nip guards will be installed on both print heads

Press will have a one-year warranty on defective parts. Motors and vacuum pump
warranted for 90 days.

Registered trademarks are the property of their owners.

 

Click on any photos below for a larger, more detailed view